Beringer Caliper with DME Rear Brake Hanger And Xtra Light Rotor – Gen 1 Hayabusa

Thoughtful delivery service

Easy 30 day returns

Certified Reviews

Description

Beringer Caliper with DME Rear Brake Hanger And Xtra Light Rotor – Gen 1 HayabusaDME Hayabusa Rear Brake Hanger with Xtra Light Rotor and Beringer Caliper (Red) Features: For Race Only Works with any type of swingarm Uses Beringer Ultralight rear caliper(PN: 2D1) Fits Only 99 07 Hayabusa No brake bar needed Brake Caliper included. Note: Must use DME Xtra rear rotor due to smaller diameter. THIS SET UP IS FOR DRAG RACING USE ONLY

Ball Joint - Greaseable - Upper - Screw-In - Low Friction - 2

Kawasaki ZX-14 / All Years

Helmet - Bandit - Snell SA2020 - Head and Neck Support Ready - Flat Black - X-Large - Each

8:1 MTC-S1261T 1327CC 8mm oversize 80MM/3

APE studs go in all the way to the bottom using all of the case thread

725 in Long - ARP2000 - Chromoly - Natural - Lentz - Set of 16

Engine Oil Pan - Fabricated - Rear Sump - 6 qt - 9 in Deep - 4-Bolt Caps - Steel - Black Powder Coat - 2-Piece Seal - Passenger Side Dipstick - Small Block Chevy - Each

Battery Disconnect Switch Boot - Accommodates 2 to 4 Gauge Wire and 3/8 in to 1/2 in Terminal Studs - Black / Red - Kit

Fuel Filter - Billet HP - In-Line - 10 Micron - Paper Element - 8 AN Female O-Ring Inlet - 8 AN Female O-Ring Outlet - Aluminum - Black / Clear Anodized - Each

Throttle Cable Bracket - Carb Mount - Return Spring - Aluminum - Clear Anodized - Lokar Cable - Dominator Flange - Kit

50 oz Cartridge - Each

Electrical Connector - Weather Pack Sealed Connector - 6 Pin - Plastic - Black - Kit

Exchange/Return Notes